These boards are designed for installation inside equipment. A pigtail is used to connect the IPEX connector on the board to the connector on the case.
Incase 38x32 DIP-28
This board is used to convert LEA family receivers into an equivalent of DIP-28 package microchips. However, you'll need to solder the pins yourself or use wires for mounting. There are no power regulators, batteries, or LEDs on this board.
ELT0015 — bare board without receiver and IPEX connector
ELT0017 — LEA-M8T receiver. For use with an active antenna only.
ELT0018 — LEA-M8S receiver. For use with an active antenna only. The board is outdated and no longer produced.
ELT0019 — LEA-M8F receiver
Incase 36x18 JST SH
There are two M3 screw holes for mounting. Interfaces: a 12-pin JST SH connector with power, USB, UART at TTL levels, and I2C contacts. SPI can be used instead of UART and I2C (to enable SPI, short the D_SEL contacts). A supercapacitor is used. Weight: 3.3 grams.
ELT0050 — NEO-M8T receiver
ELT0051 — NEO-M8L ADR receiver. For use with an active antenna only.
ELT0052 — NEO-M8U UDR receiver. For use with an active antenna only. The board is outdated and no longer produced.
ELT0053 — NEO-M8N receiver
ELT0159 — NEO-M9V ADR+UDR receiver
Incase 35x23
Interfaces: 14 contacts: power, USB, two UARTs at TTL levels, and I2C. SPI can be used instead of one of the UARTs and I2C (to enable SPI, short the D_SEL contacts). A supercapacitor is used. Weight: 4 grams.
ELT0127 — ZED-F9H receiver
ELT0128 — ZED-F9P receiver
Incase 20x10
Interfaces: 6 contacts: power, UART at TTL levels, and I2C. A supercapacitor is used. Weight: 1.5 grams.
ELT0021 — MAX-M8Q receiver.
Incase 26x16 IPEX
Interfaces: a 6-pin JST SH connector with power, UART at TTL levels, and I2C contacts. A supercapacitor is used. Weight: 2.3 grams.
ELT0022 — MAX-M8Q receiver. For use with an active antenna only.
ELT0150 — MAX-M10S receiver
© Eltehs SIA 2023
