Septentrio Mosaic Website
Find the button to open the mosaic receiver's website on the Settings page and click it.
On the website that opens, you can configure the receiver.
RxTools
You can use RxTools utilities (such as RxControl) to configure the Mosaic X5 receiver. To do this, connect via TCP/IP, using rtkbase.local or the Raspberry Pi's IP address as the address, and port 28784 as the port number.
Internet Access
The Mosaic X5 receiver is connected to the Raspberry Pi via USB. This means the receiver has the address 192.168.3.1, and the Raspberry Pi performs NAT functions for it. The Mosaic X5 receiver has nearly full internet access with a few exceptions:
- For incoming connections (IPR or the receiver's built-in NTRIP caster), only ports 3000-3009 (both TCP and UDP) are available.
- FTP access is not functional. Since the Mosaic X5 does not have its own SD card, FTP is unnecessary.
- The Mosaic X5 acts as the time server (NTP and PTP protocols), not the Raspberry Pi.
- Access to the Mosaic X5's web interface is through port 9090, while ports 80 and 443 are routed to the Raspberry Pi.
- DNS servers 8.8.8.8 and 1.1.1.1 are used for the Mosaic X5.
- The setting “Outgoing Internet Access Over USB” must not be disabled.
- The setting “Ethernet Interface Mode” must not be enabled.
- The “TCP/IP Settings” must be set to DHCP.
