Step 1: Open Settings
To detect a GNSS receiver, you need to perform the “Detect” operation in the settings. Go to the Settings page, and to the right of “Main service”, click the Options button.
Step 2: Start Detection
Click the “Detect/Configure” button and select “Detect” from the drop-down menu.
Step 3: Detection Process
The detection process will begin automatically. Once completed, the receiver is detected.
Once completed, the receiver is detected.
Step 4: Save Receiver Settings
You can then click the Apply button to save the detected receiver's settings, including:
- Port
- Speed
- Receiver name
- Protocol type
These four settings will be used later during the receiver configuration.
Step 5: Select Protocol
Septentrio receivers can operate using either the rtcm3 protocol (default) or the sbf protocol. To select the sbf protocol, change the protocol after detection and then proceed with the configuration.
